Synthetic Lube multipurpose grease for O-rings and seals. Recommended for use when installing carburetor bowl seals, O-rings*, manifold seals, slide assembly, fuel injector orings, and electrical connectors. Clear synthetic grease with PTFE is safe for use with both Viton and Nitrile seals in carburetor and intake assemblies. Comes in a small 1mL squeeze packet - use sparingly as a little goes a long way.
Recommended for:
- Carburetor seals and O-rings*
- Manifold boot seal
- Accelerator pump O-rings
- Helps holds carburetor slide diaphragm in place during assembly
- Throttle linkage lubricant
- Installing sensors or injectors with O-rings
- Dielectric electrical connector protectant
- Sparkplug wire boot lubricant
- Keeps electrical connectors dry and reduces corrosion
- Also safe for use on brake assembly hardware
* Note: Do not use on the mixture screw O-ring as the lubricant may clog the small air passages. Be sure not to block any passages with grease.
CV Performance recommends using clear synthetic grease whenever installing a Renewal Kit or Rebuild kit on your carburetor to lubricate the bowl seal, slide diaphragm seal groove, manifold boot seal, pump rod, and throttle linkage. Only use a very light coat on carburetor seals and O-rings during assembly for best results. A little goes a long way, the single 1mL packet is enough for multiple carburetor rebuilds. Withstands temps up to 450 degrees, sensor-safe (no silicone).
Product made by Super Lube®
Pictured product appearance is subject to change.
As a manufacturer and supplier we are unable to provide any repair or diagnostic advice. Please consult a factory service manual or qualified motorcycle technician.