OE

SPECIAL: Blemished Import version CV carburetor slide.  NOTE: This slide is an import that we received from a closing dealer. This item is not a CVP Brand product.  This slide is perfectly functional although they may be discolored, unpolished, or have the diaphragm slightly off center where it attaches to the slide (see example below) and the slide body is not polished. These are visual blemishes that do not impact function and are not considered a defect. Perfect for shops...

4-Sided Float fuel valve w/clip for 1989-2006 Harley CV carburetors. Replacement for OEM p/n 27886-78A. Worn float valves are the most common cause of bowl overflows and engine flooding. Refer to the float level setting diagram when installing. The setting must be adjusted since some float needle valves may be longer or shorter than others (factory made 2 versions, same number). This item is the 4-sided version however both 3 and 4 sided float valves are stated to work by the factory. All...

5/16 Fuel line for use with high flow inlets and fuel valves.  Made in the USA 5/16" I.D. x 9/16" O.D. Black neoprene line is reinforced with a high strength rayon mesh Resists fuel additives and short term use of pump gas with E10 Ethanol* Maximum PSI of 200 with a burst pressure of 450 PSI Use with CVP Fuel Inlet or other brass/steel type inlet elbows**  Length provided to fit all Harley carbureted models NOT for use on fuel injected models. Ideal for high volume...

Complete rebuild kit for Mikuni HSR 42 and 45 carburetors. SALE - Blemished Kits. These kits were stored by the supplier in a humid warehouse and therefore the brass needle seat may be tarnished or require cleaning before installation. We are offering these kits as a close-out at this reduced price while supplies last. Included in kit:(1) Float needle and brass seat with o-ring(1) O-ring(1) Gasket(6) O-rings(1) Flat O-ring(1) Rubber boot(1) E-clip(1) Plastic washer(4) #8-32 x 7/16 in. bowl...

Enrichener choke cable for Harley CV carburetors. Replaces original p/n #29229-88D cable and all other Harley CV enrichener cables for big twin and Sportster. The OE cable is ideal when used with our choke bracket and has a shorter rigid section to prevent interference with the fuel inlet elbow. Close out item while supplies last Replacement for Harley p/n 29229-88D and 29236-90 See p/n 29238-92 for the shortest available cable. Import clearance item Fits all Harley CV...

Float fuel valve w/clip for 1988-2018 Kawasaki CVK40 carburetors. Commonly found on KLR650 models. Replacement for Keihin / Kawasaki part number 16030-1057.  Note: See your factory service manual or consult a service technician if not already familiar with the service procedures required for installation.  Fits various Kawasaki models, verify your model accepts part number 16030-1057 before purchase.  We are unable to exchange float valves if you order the...